SMA-100路用木質素纖維
產品簡介：
SMA-100路用木質素纖維是以天然木纖維為主要原料，通過篩選、分裂、高溫處理、漂白、化學處理、中
和、篩分，再添加一定質量的非金屬超細礦粉進行復合處理而得到的一種路用工程材料。它能很好的與瀝青、
礦粉，少量的細集料組成瀝青瑪蹄脂結合料，包裹在粗集料表面，使粗集料具有良好的嵌擠性能。最高拌合溫
度可達200℃,鋪筑溫度可達180℃。這種路面具有抗酸、抗堿、抗滑耐磨、抗疲勞、抗高溫車轍、密實耐久,減
少低溫開裂等優異性能。
SMA-100路用木質素纖維是SMA中首選的纖維穩定劑，它可以吸持混合料中的瀝青，使其在拌和、儲存、運
輸、攤鋪過程中保持相對穩定狀態，防止滴漏現象的發生。廣泛用于瀝青混凝土路面，包括：瀝青瑪蹄脂碎石
混合料（stone Mastic Asphalt,簡稱SMA）路面、升級配瀝青路面（OGFC）、高強度瀝青連接層、瀝青混凝土
面層、澆注式瀝青混凝土及特殊工程的瀝青混合料等。
應用范圍:
※高建公路，一級公路做抗滑表層 ※機場建設 ※舊公路養護 ※橋面鋪裝
性能指標：
|
試驗 |
指標 |
|
篩
分
析 |
沖氣篩分析 |
纖維長度 |
＜6mm |
|
通過0.15mm篩 |
（70±10）％ |
|
普通篩分析 |
纖維長度 |
＜6mm |
|
通過0.85mm篩 |
（85±10）％ |
|
通過0.425mm篩 |
（65±10）％ |
|
通過0.1106mm篩 |
（30±10）％ |
|
灰粉含量 |
（18±5）％無揮發物 |
|
PH值 |
7.5±1.0 |
|
吸油率 |
纖維質量的（5.0±1.0）倍 |
|
含水率 |
＜5％（以質量計算） |
|
纖維寬度 |
＜0.045mm |
|
松散密度 |
0.2～0.4g/cm3 |
使用方法：
建議使用專用設備或預分散處理。將SMA-100與熱集料一起干拌，干拌時間的確定應以纖維能均勻的分散
開為原則。
摻加比例：
以瀝青混合料總量的質量百分比計算，摻加量宜為瀝青混合料的0.3％～0.4％，摻加量允許誤差為纖維質
量的±５﹪。
包裝儲運：
１、本產品為5公斤/袋，貯存有效期為24個月，超期經試配試驗后仍可使用。
2、應貯存于干燥通風處，注意防潮、防雨、防明火。
SMA-100 fiber-shaped road with lignin
Product brief introduction:
SMA-100 fiber-shaped road with lignin is made with a natural wood fiber as its main raw material and be used as a way of engineering materials through the process of filter, split, high-temperature treatment, bleaching, chemical processing, neutralization and screening, then add a certain quality of non-metallic ultra-fine powder for composite treatment. It is a fine aggregate component combined with the asphalt, slag, small amount of Asphalt binder. After wrapped in coarse aggregate surface, coarse aggregate will have a good embedded and crowded performance. The maximum mixing temperature will be 200 ℃ and the paving temperature can reach 180 ℃. This road has its outstanding performance such as acid-fast, alkali resist, anti-sliding wear resistance, anti-fatigue, anti-high-temperature rutting, compacting durable, reducing and low-temperature cracking.
SMA-100 fiber-shaped road with lignin are the preferred stabilizing agent in SMA fibers, it has Sorption to asphalt among Mixtures to make sure which has a maintaining relatively stable state in the process of mixing, storage, transport, paving to prevent the trickle down phenomenon.
SMA-100-type road with lignin fibers are widely used in asphalt concrete pavement, including Asphalt gravel mixture (stone Mastic Asphalt, referred to as SMA) road, Upgraded with asphalt pavement (OGFC), high-strength link layer of asphalt, asphalt concrete surface layer of mastic asphalt concrete and special projects such as asphalt mixture.
Scope of application:
※ High-built roads, a highway to do anti-slide surface
※Airport Construction ※Damaged Highway Maintenance ※Bridge Deck
Performance indicators:
|
Trial |
Indicators |
|
Sieve analysis |
Inflatable sieve analysis |
Fiber length |
＜6mm |
|
Through 0.15mm sieve |
（70±10）％ |
|
Ordinary
sieve analysis |
Fiber length |
＜6mm |
|
Through 0.85mm sieve |
（85±10）％ |
|
Through 0.425mm sieve |
（65±10）％ |
|
Through 0.1106mm sieve |
（30±10）％ |
|
Ash content |
（18±5）％Non-volatile matter |
|
PH value |
7.5±1.0 |
|
Absorption rate |
（5.0±1.0） times the fiber quality |
|
Moisture content |
＜5％(In quality terms) |
|
Fiber width |
＜0.045mm |
|
Loose density |
0.2～0.4g/cm3 |
Usage:
Recommend to use special equipment or pre-dispersion treatment. Make SMA-100 together with hot mix aggregate , Follow the principle to make sure fiber be evenly dispersed.
Mixing ratio:
Asphalt mixture to the quality of the total percentage terms, adding appropriate amount of asphalt mixture for 0.3% ~ 0.4%, adding the volume of allowable error for the fiber quality of ± 5%.
Packaging storage and transportation:
1, The weight of product is 10 kg / bag, the valid storage period is 24 months. Those extended can still be used after tests.
2, Product should be stored in a dry well-ventilated place Attention to moisture, water-resist and anti-fire.
|
